Types of motors:
Hey, don't power the motor from the regulated supply that is running your processor... use the unregulated DC and connect the controller to the motor via a semiconductor like a transistor, mosfet, etc...
Lance Allen says
[Ed: Rather than relays or H-Bridges or PIDs in many cases you can drive a moter with a..] N channel LOGIC LEVEL mosfet such as RFD14N05L or even up to BUZ101L ( good for 29 amps). They are cheaper than a relay [ed: or anything else] and dont need another drive transistor.
The Mosfet connects the gate directly to the [uProcessor or control curcuit], the source to 0 volts and the drain to the motor -ve, motor +ve goes to +5volts. You will need a reverse biased diode across the motor for back EMF suppression, such as 1N4004
When the motor stops rotating it'll stop making back EMF and the voltage across it will drop. You can use an op amp as a comparator.
Rewinding motors for higher RPM: fewer winding turns of larger diameter wire = more current = higher RPM
an addition to -->'motor control chips'+
LM628 and LM629 high precision motion control IC's. Apt for control by a uC. expensive, ~$30.
LM18201 National Semiconductor single package, 3A 55V h-bridge. ~$8.
|file: /Techref/io/motors.htm, 9KB, , updated: 2021/9/18 11:07, local time: 2022/11/29 10:48,
|©2022 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.ecomorder.com/techref/io/motors.htm"> gear motor, stepper motor, DC motor, Brushless motor, Motor Driver, H-Bridge, PWM, PID</A>
|Did you find what you needed?|
Welcome to ecomorder.com!
Welcome to www.ecomorder.com!