please dont rip this site

Digital Logic Tutorial

The D Flip Flop

Computers use only two numbers: 0 and 1, which are represented by on or off on a single wire. The RS Flip Flop can't really remember the state of a single wire; it uses two different wires and remembers which one was pressed last.

Here we show the D Flip Flop which is really a bit of digital memory. It has one "D" or Data wire and a "CLK" or clock wire which causes the state of the D wire to be remembered.

If you can't see the simulation below, try this HTML version of the Falstad simulator: D Flip Flop

Digital logic builds, from the absurdly simple to the massively complex. The trick is to make the simple circuit into a block, or module, that you can use to build more complex circuits. The circuit on this page is shown as one of those "stackable" blocks at the bottom of the simulation. The box there contains the circuit at the top of the page. It has inputs and outputs which connect to the NAND gates inside the block or module, as it's called in LogicSim.

Advanced

Notice that the RS Flip Flop is actually still in there: We actually just added a "NOT D" line from the "D" line and made the clock line necessary for either of those to pass.

Next: The 4 bit Register, or Binary and Decimal Numbers

Also:

Comments:

See also:


file: /Techref/logic/DFlipFlop.htm, 3KB, , updated: 2015/10/19 15:03, local time: 2024/12/13 05:13,
TOP NEW HELP FIND: 
18.97.14.84:LOG IN

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://www.ecomorder.com/techref/logic/DFlipFlop.htm"> Digital Logic Tutorial, D FlipFlop, D type flip flop.</A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?

 

Welcome to ecomorder.com!

 

Welcome to www.ecomorder.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .